Marlin 3D Printer Firmware for Sovol SV01. Contribute to CopterTec/Marlin-SovolSV01 development by creating an account on GitHub. This article descripes the steps when you install the Marlin firmware on a RepRap controller using the combination of an Arduino Mega 2560 and the RAMPS 1.4 shield. Preconditions: As preconditions for the next steps you need some software packages from different sources.
To install Marlin on your printer you’ll first need to Download Marlin, then edit your Configuration files, and finally use an IDE to Compile the Marlin project into a binary form and Upload it to your board. The build process can seem daunting at first, but after you do it a few times you’ll be a pro.
Marlin only needs to be re-flashed when fixed settings are changed in the configuration files. Many settings are only defaults and can be changed (and saved to EEPROM) with G-codes. See each option’s description in the configuration files to find out which G-codes apply.
Download
Start by downloading the Marlin source code. There are a few codebases to choose from.
Download 2.0.x | Current release |
Download 1.1.x | Previous release |
Download 1.0.x | Older release |
Download bugfix-1.1.x | “Nightly” build. Proceed with Caution! |
Download bugfix-2.0.x | “Nightly” build. Proceed with Caution! |
- Marlin 1.0 does not support PlatformIO. For older versions of Marlin use Arduino IDE.
- Marlin 1.1 fully supports PlatformIO, and Marlin 1.1.9 even provides an automated build process.
- Marlin 2.0 and up include 32-bit ARM support. PlatformIO is not required for AVR boards.
Configure
To configure Marlin you can use the Arduino IDE or your favorite text editor to edit the
Configuration.h
and Configuration_adv.h
files. See Configuring Marlin for full details.Build and Install
Marlin installation procedure can vary depending on which version of Marlin you want to install and which board you’re installing onto. Once your Marlin build environment is set up installing updates can be a one-click operation.
Marlin Version | Platform(s) | Instructions |
---|---|---|
1.1.x or 2.x | 8-bit AVR | Install Marlin with Arduino IDE |
1.1.9 or 2.x | 8-bit AVR, 32-bit ARM | Install Marlin with PlatformIO |
2.0 | LPC1768 (Re-Arm) | Install Marlin on Re-ARM |
Marlin Firmware Home
Looking for Example Configurations for your machine?
- Marlin 1.1.x : Included in the ‘
example_configurations
’ folder. - Marlin 2.0.x : Hosted separately. Links on the Downloads page.
Troubleshooting
Marlin Firmware Configuration Wizard
Troubleshooting a complex piece of software with a minimal interface can sometimes be challenging, even for the most experienced 3D printing enthusiast. Please use our Troubleshooting Guide for tips on some common problems.